Boxster S (987) F6-3.4L (2008)
INFORMATION: Before disconnecting the battery, move the seat to the uppermost position.
1. Unlock and separate the electrical plug for the seat.
2. Connect plug of adapter cable 9257/6 to the electrical plug for the seat.
3. Connect ignition device No. 9257 to the 2-pin plug of adapter cable No. 9257/6.
4. Place the ignition device in front of the vehicle through the door gap and trigger it.
Head airbag
Remove door trim panel. Refer to Removing and installing the door trim panel
1. Connect plug of adapter cable 9257/3 to the head airbag.
2. Connect ignition device No. 9257 to the 2-pin plug of adapter cable No. 9257/3.
3. Place the ignition device in front of the vehicle through the door gap and trigger it.
Belt tensioner
Remove the side panel lining at rear. Refer to Removing and installing rear side panel lining
1. Connect plug of adapter cable 9257/3 to the belt tensioner.
2. Connect ignition device No. 9257 to the 2-pin plug of adapter cable No. 9257/3.
3. Place the ignition device in front of the vehicle through the door gap and trigger it.
Triggering of airbag units
WARNING: Detonation of airbag units.
-
Danger of injury from emerging objects, e.g. splinters.
-
Hearing impairment by explosion noises.
-
Danger of burns from hot airbag units.
-
Danger of poisoning by emerging gases.
-
Observe a safety distance of at least 10 m.
-
Wear hearing protection.
-
Each airbag unit, the respective ignition stages 1 and 2, and each belt tensioner must be triggered individually.