Boxster S (987) F6-3.4L (2008)
Cross member
3. Install eccentric threaded joints (toe and transverse control arm) at rear-axle carrier side section.
Rear-axle carrier side section
3.1.
Install toe eccentric threaded joint between transverse strut and rear-axle carrier side section.
Set the basic position of the toe eccentrics at the marked position -see arrow- on the rear-axle carrier side section and tighten nuts.
3.2.
Install camber eccentric threaded joint between toe control arm and rear-axle carrier side section.
Set the basic position of the toe eccentrics at the marked position -see arrow- on the rear-axle carrier side section and tighten nuts.
4. Insert support plate and align rear-axle carrier side section.
Insert the support plate and secure it to the following components, see -arrows- :
Rear-axle carrier side section, cross member, V-brace
Align rear-axle carrier side section as required until the hole patterns are perfectly matched. It must be possible to insert the support plate without
tension.