Boxster S (987) F6-3.4L (2008)
/f6-3.4l/Page-698005.png)
Information: The wheel bearings adopt the function of the former ABS pulse rings. They are fitted with a so-called multipole seal. This is a seal with
a magnetized layer, which generates the torque impulses for the ABS rpm sensors.
The multipole seal must not come into contact with highly magnetic parts. During installation, make sure that the magnetic side is facing the ABS
sensor. Use test card 147-2 for this.
Heat up wheel bearing housing before pressing in the wheel bearing.
Preparatory condition: --> Temperature: 100°C+20°C
Insert wheel bearing at the correct position, then press again on the wheel bearing housing with only slight force using a suitable pressure piece
(9247/4), see pressure piece (4 x) P 9247 and tubular piece VW 415 A.
Pressing in wheel bearing
Warning: Hot wheel bearing housing!
^
Danger of burns
--> Wear heat-resistant gloves!
2. Install bearing cover -2-.
Screw in and tighten screws -1-. --> Tightening torque: 37 Nm (27 ftlb.)
Installing bearing cover
3. Press in wheel hub.
Position wheel bearing housing on wheel hub and press on wheel bearing inner race using a tubular piece VW 415 A.
