Boxster S (987) F6-3.4L (2008)
Releasing electric connector
3. Take out the control unit.
Installing Tiptronic control unit
Installing Tiptronic control unit (also referred to generally as control unit below)
1. Connect the connector to the control unit and insert the closing clip until it engages.
Connecting electric plug
2. Position control unit and secure with the fastening nuts. --> Tightening torque: 7.5 ftlb.
Screw down control unit with fastening nuts.
3. Fold back the carpet lining into position and fasten with the clips.
Subsequent work
Subsequent work for Tiptronic control unit
Fold back the carpet lining and fasten with the clips.
If a new or different Tiptronic control unit has been installed then code it using the PIWIS Tester 9718.