Boxster S (987) F6-3.4L (2008)
Detaching drive plate
3. Loosen fastening screw for toothed segment.
Installing drive plate for converter
Installing drive plate for converter
1. Position drive plate on the crankshaft's dowel pin and press on to the crankshaft flange. Insert all M10 x 25 fastening screws (8).
2. Align toothed segment 9538/1 and tighten fastening screw again.
3. Screw in and tighten fastening screws in diagonally opposite sequence. --> Initial tightening: 25 Nm (ftlb.) (19); --> Final tightening - torque
angle: 120°
4. Remove toothed segment.
Subsequent work after installing drive plate for converter
Subsequent work after installing drive plate for converter
1. Install automatic transmission.