Boxster S (987) F6-3.4L (2008)
Special tool
6. Drain oil for final drive.
7. Remove the differential.
Removing double sealing ring
Removing double sealing ring
Information: The adjusting shim is calibrated and cannot be exchanged for a different shim.
1. Remove outer bearing ring -1- and adjusting shim -2- from the transmission housing by hand.
Outer bearing ring and adjusting shim
Information: Hook VW 681 must be fitted behind both sealing lips of the sealing ring because fitting it on the outer circumference of the sealing ring
can damage the contact surface in the transmission housing. Guide the tool carefully while pulling out.
2. Carefully pull out sealing ring with hook VW 681.
Removing sealing ring
Installing double sealing ring