Boxster S (987) F6-3.4L (2008)
Shift Cable: Service and Repair
WM 341219 Removing and installing shift and selector cables
Preliminary work
Preliminary work
1. Raise the vehicle at the prescribed jacking points.
2. Remove support plate.
3. Remove rear wall cover.
4. Remove engine-compartment lid.
5. Remove shift lever knob.
6. Remove center console.
7. Remove parking-brake lever.
Removing shift and selector cables
Detaching shift and selector cables at transmission
1. Lever off shift cable (with grey sealing cap) -1- and selector cable (with blue sealing cap) -2- from ball pin and detach from supports.
Shift and selector cables
Detaching shift and selector cables inside vehicle
1. Locking bridge P 9619/1 must be fitted on the gearshift bracket.