Cayenne (92A) V6-3.6L (2011)
1.1 Grind the threaded bush -1- bright on the contact surface with the seat cross member.
2. Inserting threaded bush.
2.1 Insert a new threaded bush -1- fully into the seat cross member from below.
2.2 Set the threaded bush -1- at a slight angle.
2.3 Insert an M8 x 120 bolt -2- into the seat cross member from above.
2.4 Screw the bolt -2- approx. three revolutions into the threaded bush -1-.
2.5 Pull the threaded bush -1- with the screw -2- up to the seat cross member.
3. Position the threaded bush and weld it into place.
3.1 Align the threaded bush -1- in the middle.
3.2 Weld the threaded -1- insert into the existing holes using MIG welding.