Cayenne (9PA) V6-3.2L (2006)
/v6-3.2l/Page-1616014.png)
Installing front-axle carrier - V8
ATTENTION:
Increased risk of accidents when running in the front axle carrier.
^
Material damage and injury can occur.
^
Material damage and injury if the wheel carrier is raised improperly.
^
Position the mounting frame correctly on the lifting platform and carefully install the front axle carrier.
^
Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels). When raising the suspension, use a
suitable intermediate layer (hard rubber).
^
Do not damage the brake cover plate.
^
Watch out for falling parts during installation on the mounting frame.
^
The steering angle sensor must be calibrated following repairs.
Note:
^
Before installing, give the parts a visual check.
^
Note previously applied markings on the front axle carrier and on the cardan shaft.
^
A second worker is required in order to avoid damaging adjacent components when fitting the front axle carrier.
^
When fitting the ball joints, ensure that the bevel pinions are clean! Remove dirt or grease on bevel pinions, e.g. with a lint-free cloth. Do not use
cleaning agent/solvent.
^
Replace all fastening nuts and all expansion screws (screws which are fitted with torque angle tightening procedure).
^
The entire threaded parts of the axle must be tightened in vehicle position. Vehicle position means: vehicle standing on the wheels, or the wheel
suspension is raised using a universal vehicle lift. -Dimension X-, corresponds to vehicle position. Check dimension: 502 mm ± 10 mm
^
Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels). When raising the suspension, use a suitable
-intermediate layer (hard rubber)-. Do not damage the brake cover plate.
^
Bleed power-assisted steering.
^
Observe correct tightening torques.
^
Align vehicle.
