Cayenne GTS (9PA) V8-4.8L (2008)
4.3. Lift trim up and off -arrows D-.
Installing reversing camera
1. Install trim.
1.1. Open trim slightly counter to the spring tensioning -arrow E-.
1.2. Insert trim from above on housing -arrows G- and push down and in -arrows F-. As shown in the cross section, the cover must be hooked
securely onto the camera and must not rattle.
1.3. Screw in fastening screws -4- and tighten to the specified tightening torque. - Tightening torque: 0.5 Nm (0.5 ftlb.)
1.4. Screw in fastening screw -3- and tighten to the specified tightening torque. - Tightening torque: 0.5 Nm (0.5 ftlb.)
2. Screw in fastening screws -2- and tighten so that camera -1- can still be moved.
3. Adjust seam joining line.
3.1. Adjust seam joining line at the side -I-. - Gap dimension: 3 mm