Cayenne GTS (9PA) V8-4.8L (2008)
-
Hardened paintwork, sanded
-
Sheet steel, aluminum and UP-GF, sanded
-
Hardened Standoflex(R) 2K Plastic Primer Surfacer / Standox(R) 2K Universal Filler / Standox(R) 2K Nonstop Primer Filler, sanded
-
Primed hard plastics
-
Please note base surface pre-treatment instructions:
-> S 5.1
-> S 6.1
-> S 9.2.2
NOTE:
-
Raw material base: Unsaturated polyester resin
-
Flash point: 33° C/91.4° F
-
Spec. weight: 1.79 g/cm3
-
Solid content: 83.9% weight/67.7% vol.
-
Storage: Polyester materials have a limited shelf life; always store in a cool place. Application within 12 months guarantees perfect results.
-
Use Standox(R) PE Soft Stopper on galvanized base surfaces
-
Do not use on acid primer, Standohyd(R) 1K Primer Surfacer, TPA paint finishes and elastic-rendered old paint finishes
-
Do not apply below +5° C
-
Mix 2-3% Standox(R) Hardener Paste red and stopper well. Try not to overdose as this can result in discoloration of the final paint finish.
-
Clean equipment after use with cleaning thinner
VOC value:
-
284 g/l
WARNING:
-
Hardener pastes contain organic peroxide and have a corrosive effect. Wipe off splashes on the skin immediately and wash with soap and
water.
-
Rinse out splashes in the eyes with plenty of watery 2% sodium carbonate solution or plenty of water. Consult a doctor immediately.
S 9.4.1.1 Processing
S 9.4.2 Standox(R) Etching Adhesion Primer