Cayenne GTS (9PA) V8-4.8L (2008)
Bar ignition modules and valve cover, cylinder bank 5 to 8
1 - Valve cover for cylinder bank 5 to 8 (align over bar ignition modules)
2 - Eyelet
3 - Eyelet (with steel screw) - Tightening torque: 23 Nm (17 ftlb.)
4 - Aluminum screw, M6 x 30; always use new aluminum screws; - Initial tightening: 4 Nm (3 ftlb.) and - Final tightening: 90°
5 - Bar ignition module
6 - Aluminum screw, M6 x 20; bar ignition module; always use new aluminum screws; - Initial tightening: 4 Nm (3 ftlb.) and - Final tightening: 90
°
7 - Sheet metal holder
8 - Cap
A - Direction of travel
- Not shown; design cover on bar ignition modules - Tightening torque: 4.4 Nm (3.0 ftlb.)
6. Fit wire harness holder. To do this, press on the wire harness holder.
Wire harness holder
7. Connect the cable plug for the hydraulic valve and fit the cap.