Cayenne GTS (9PA) V8-4.8L (2008)
2. Pull out oil dipstick.
3. Pull guide tube out of the oil guide housing. Carefully turn back and forth if necessary. Check that the sealing ring on the guide tube moves with it
or pull the sealing ring out of the bore using an angled piece of wire.
Installing guide tube for oil dipstick
Information
Illuminate the installation location well for assembling the guide tube.
1. Replace sealing ring.
2. Push guide tube into the oil guide housing. Fit and tighten screws. -3 and 11-
Oil guide housing with accessories
1 - Guide tube
2 - O-ring
3 - Screw, M6 x 16 - Tightening torque: 10 Nm (7.5 ftlb.)
4 - Oil dipstick
5 - O-ring
6 - Screw, M6 x 25; timing-case cover to oil guide housing; oil-level sensor to oil guide housing; oil guide housing to lower part of crankcase
7 - Oil-level sensor
8 - O-ring
9 - Joint flange
10 - Screw, M6 x 20
11 - Screw, M6 x 16 - Tightening torque: 10 Nm (7.5 ftlb.)
A - Direction of travel
Subsequent work
1. Install intake pipes upstream of the throttle valve.