Cayenne GTS (9PA) V8-4.8L (2008)
/v8-4.8l/Page-257001.png)
Balance Shaft Seal: Service and Repair
Removing and installing sealing ring for vibration balancer on DFI engines
Information
Component changes for model year 2009 as of October 2008
Information
Always read the information concerning modified tightening specifications and component changes relating to repairs provided for specific engine
numbers in the Information section.
Preliminary work
1. Remove vibration balancer.
Removing sealing ring for vibration balancer
1. Unscrew the four fastening screws and remove the cover with the sealing ring.
Removing cover with sealing ring
2. Clean the sealing surface of the sheetmetal cover.
Installing sealing ring for vibration balancer
Warning
Risk of damaging the sealing ring due to assembly fault!
Never pull the sealing ring from the plastic sleeve!
Do not touch the sealing lip!
Do not oil the sealing ring on the running surface!
-
Sealing lip can be damaged!
Information
If the joint flange on the pulley or the surface on the crankshaft stub is slightly rusted, polish the rust off with a special polishing pad.
If there is bad corrosion or deep grooves, replace these components.
