Cayenne GTS (9PA) V8-4.8L (2008)
4. Position heater on holder and secure with the fastening screws -1-. - Tightening torque: 8 Nm (6 ftlb.)
5. Secure water tube at the heater.
INFORMATION: Before connecting the water hoses, apply suitable rubber lubricant to the flanges.
5.1. Place water tube in installation position and slide it onto the heater -arrow A-.
5.2. Slide spring band clamp onto the connection using the assembly pliers for spring band clamps, Cayenne hose connections NR.72-1 ( -arrow
B- ) and align with the markings.
5.3. Slacken spring band clamp -arrows C- and secure the hose.
INFORMATION:
-
Make sure the water tube holder is installed at the correct position.
-
The exhaust pipe runs behind the water tube holder.
6. Install water tube holder.
6.1. Position water tube holder -3- ( -arrow- ).
6.2. Tighten fastening screw -2-. - Tightening torque: 4.5 Nm (3.5 ftlb.)
6.3. Tighten fastening nuts -1-. - Tightening torque: 6 Nm (4.5 ftlb.)
7. Position water tube on holder and secure with a blind rivet -1- (4.8 x 10).