Cayenne GTS (9PA) V8-4.8L (2008)
3. Slide fuel pump together with the rubber sleeve onto the holder -arrow-.
4. Install cover plate.
4.1. Insert cover plate -arrow- and screw down with the fastening screws -2-. - Tightening torque: 10 Nm (7.5 ftlb.)
4.2. Tighten fastening nut -1-. - Tightening torque: 10 Nm (7.5 ftlb.)
5. Plug in connector on the fuel pump -arrow- until the connector engages securely.
6. Secure fuel line on tank.
6.1. Connect plug-in coupling onto tank connection -arrow A- until the retaining clip -arrow B- engages securely.
6.2. Press fuel line into the holder -arrow C- until the fuel line engages securely.
INFORMATION:
-
The fastening screws for the seat-belt buckle bracket must be replaced.
-
The removed fastening screws must not be re-used.
7. Install tank cut-out cover.
7.1. Insert tank cut-out cover -arrow A- and screw down with the fastening nuts -arrows 6-. - Tightening torque: 9 Nm (6.5 ftlb.)
7.2. Fold back the carpeted floor -arrow B-.