Cayenne GTS (9PA) V8-4.8L (2008)
3.2. Unscrew fastening nuts -arrows 2- and remove trim panel.
4. Release line bracket -arrow A-, open it -arrow B- and unclip fuel line -arrow C-.
INFORMATION: Before disconnecting the fuel line, it is essential to observe the safety instructions.
5. Loosen and remove fuel line.
5.1. Release hose clamps -1- at the fuel pump and at the connecting point in the wheel housing.
5.2. Pull out fuel line at both ends of the connections -arrows-.
6. Remove fuel line.
6.1. Press out fuel line together with the rubber sleeve -arrow A- by pressing inwards -arrow B-.
6.2. Remove the fuel line first to the rear -arrow C- and then downward -arrows D-. Twist the fuel line slightly when removing it if necessary.
Installing fuel line - fuel pump to wheel housing connection
1. Install fuel line.
1.1. Coat rubber sleeve -arrow A- with a suitable sliding compound.
1.2. Slide fuel line from below along the cardan tunnel -arrows B- and guide it through and out at the wheel housing -arrows C-. Twist the fuel
line slightly when installing it if necessary.