Removing and Installing Compressor-Condenser Line for Cayenne GTS (9PA) V8-48L (2008)
1. Remove the plugs on the pressure line, check the O-rings and replace if in doubt.
2. Raise the auxiliary air-conditioning unit and push the pressure line onto the connections -arrow- and screw down with both fastening screws -1-. -
Tightening torque: 12 Nm (9.0 ftlb.)
3. Ensure that the water drain is connected to the drain when fitting the auxiliary air-conditioning unit.
Subsequent work
1. Fill in refrigerant.
2. Screw down auxiliary air-conditioning unit.
3. Install rear side trim panel.
Removing and Installing Suction Line In Vehicle
Removing and installing suction line in vehicle
Technical values
Preliminary work
1. Remove rear side trim panel.
2. Unscrew auxiliary air-conditioning unit.
Removing suction line in vehicle
CAUTION: Danger of injury from contact with the refrigerant
-
Observe safety regulations when working with refrigerant.