Cayenne GTS (9PA) V8-4.8L (2008)
Headlamp Alignment Sensor: Service and Repair
Removing and installing rear angle sensor for headlight beam adjustment
Tools
Technical values
Removing rear angle sensor for headlight beam adjustment
INFORMATION:
-
The angle sensors are installed together with the Bi-XENON headlights and the steel-spring running gear.
-
An angle sensor is located at the front left and rear left in running gears with steel springs.
-
The angle sensor is screwed to the suspension subframe and upper control arm.
1. Counter with an open-ended wrench on the two flats -1- and unscrew the fastening nuts -2-.
2. Unscrew both fastening screws -3-.
3. Press the electric connector together -a- and pull it off.
Installing rear angle sensor for headlight beam adjustment
INFORMATION: If a new angle sensor has been installed for headlight beam adjustment (HBA), the headlights must be recalibrated using the
Porsche System Tester.