Cayenne GTS (9PA) V8-4.8L (2008)
3. Attach the refrigerant lines in the engine compartment to the connections (do not tilt) and screw down using the fastening screws -1-. - Tightening
torque: 9 ftlb.
4. Screw down the fastening nuts to the fastening clamps of both refrigerant lines. - Tightening torque: 6 ftlb.
5. Carefully place refrigerant lines onto expansion valve and press into place (do not tilt) and screw down using the two fastening screws. -
Tightening torque: 9 ftlb.
6. Push electrical plug onto pressure switch until it clicks into place.
Installing the (B - C) line on the condenser - evaporator
INFORMATION:
-
Always replace the sealing rings of the refrigerant lines.
-
Spray the sealing rings with refrigerant oil before fitting.
-
The condenser - evaporator line can only be installed together with the compressor - evaporator line.
1. Lift the vehicle. Hold both refrigerant lines together, twist them, and insert them from below through the left wheel housing opening.