Cayenne GTS (9PA) V8-4.8L (2008)
Installing
Installing rear wheel bearing
Information
^
The wheel bearing must not come into contact with magnetic objects (e.g., magnetic screwdriver, magnet).
^
The entire threaded parts of the axle must be tightened in vehicle position. Vehicle position means: vehicle standing on the wheels, or the wheel
suspension is raised using a universal vehicle lift. Dimension -X-, from lower edge of wing to middle of axle 506 mm ± 10 mm corresponds to
vehicle position.
^
Use an intermediate layer (hard rubber) ! Do not damage the brake cover plate.
^
Screws and nuts are Dacromet(R)-coated and must not be greased.
^
Grease axle nut with a little Optimoly TA aluminium paste only at mounting-face ring.
^
Grease the toothing of the drive shaft slightly with aluminium paste Optimoly TA.
^
Drive shafts must not be left hanging from the joint stop! Tie up.
^
Use new screws and lock nuts.
^
The wheel bearing seat must be free of grease.
^
Observe correct tightening torques.
1. Fit the wheel bearing (tools).