Cayenne GTS (9PA) V8-4.8L (2008)
INFORMATION:
-
The repair instructions document "Main wire harness" is divided into several chapters because of its size.
-
For body repairs, refer to the specific chapters on installing and removing individual sections of wiring.
CAUTION:
-
The main wire harness contains all airbag lines, antenna lines and optical waveguides.
-
The main wire harness must therefore not be cut for major repair work and must be replaced complete.
-
If individual lines are damaged, isolate them (disconnect, remove plug contacts from plug connections etc.) and replace the original wire
harness by installing new lines.
Removing main wiring harness - floor area and left-hand side
Disconnect the battery.
Remove side trim panel for rear luggage compartment.
Remove left rear light.
Remove rear seat.
Remove left B-pillar trim panel.
Remove front left side-section trim panel.
Remove subwoofer.
Remove auxiliary battery.
Remove floor carpeting from the work area.
CAUTION:
Danger of injury and material damage if airbag units are not handled correctly. Always observe the safety regulations for handling airbag
units.
-
Remove ignition key. Disconnect battery. Route or isolate the ground strap so that all contact with a ground carrier (e.g. body, seat
frame) is avoided.
-
After the battery is disconnected, always wait for 1 minute before disconnecting the airbag plugs.
1. Lift vehicle.
Only for vehicles with off-road stabilizer and/or tyre pressure monitoring system
2. Release plug connection for off-road stabilizer (rear wheel housing) -1- -Arrow A- and disconnect it - Arrow B-.
3. Release connector of antenna for tyre pressure monitoring system (rear wheel housing) -2- -Arrow C- and disconnect it -Arrow D-.