Cayenne GTS (9PA) V8-4.8L (2008)
Installing main wiring harness - dashboard area.
Installing main wiring harness - centre console.
Installing main wiring harness - floor area and right-hand side
INFORMATION:
-
The repair instructions document "Main wire harness" is divided into several chapters because of its size.
-
For body repairs, refer to the specific chapters on installing and removing individual sections of wiring.
1. Fit wire harness with wiring duct (rear door floor area) on threaded bolts -Arrows A- and fasten with two new tie-wraps -B-.
2. Fit line (B-pillar floor area) on threaded bolts -Arrows A-.
Only for vehicles with level adjustment.
3. Insert air tubes in wiring duct -Arrows B- and close the wiring duct -Arrow C- until locking tabs are felt to engage.
4. Push line (under right front seat) onto threaded bolt -Arrow A-.
5. Fit ground strap together with the twist lock on the threaded bolt -Arrow B- bolt and screw down with the fastening nut -1-. - Tightening torque:
6.5 ftlb.
6. Push line down through transmission tunnel -Arrow C-.