Cayenne GTS (9PA) V8-4.8L (2008)
25. Place rear seat support in installation position -Arrow A- and secure with fastening screws -5-.
26. Press the corrugated hose holder onto the threaded bolt -Arrow B-.
27. Clip line to the rear seat support -Arrow C-.
28. Insert line in the clip -Arrow D- and close clip -Arrow E- until the locking tabs are felt to engage.
29. Push on connector -Arrow F- until locking tab -G- is felt to engage.
30. Push in connectors on KESSY antenna (under rear seat) -Arrow A- until locking tabs -B- are felt to engage.
31. Place KESSY antenna in installation position -Arrow C- and fasten with the styrofoam elements - Arrow D-.
32. Fit wiring duct on threaded bolt and wheel housing seam -Arrows A-.
33. Fit ground strap together with the twist lock -a- on the threaded bolt -Arrow B- and screw down with the fastening nut -1-. - Tightening torque: 6.5
ftlb.
34. Press down the protective cover on the plug -Arrow A- and maintain in this position.
35. Remove airbag sensor on C-pillar.
36. Press down protective cover on connector (C-pillar) -Arrow A- and maintain in this position.
37. Insert connector -Arrow B- until locking tab -C- is felt to engage.
38. Fasten line with a new tie-wrap -D-.
39. Push in connectors (filler-flap lock) -Arrow A- until locking tabs -B- are felt to engage.