Cayenne GTS (9PA) V8-4.8L (2008)
6. Insert the air duct from below -Arrow- and secure with fastening screws -1-.
7. Secure the oddments tray with fastening screws -1-.
8. Install centre console vent.
Subsequent work
1. Install centre console.
Removing and Installing Wire Harness For Parkassist
Removing and installing wire harness for ParkAssist
Preliminary work
1. Remove rear apron.
Subsequent work
1. Install rear apron.
Removing and Installing Wire Harness In Engine Compartment
Removing and installing wire harness in engine compartment
Preliminary work
1. Remove insulation for engine compartment lid.
2. Remove cowl panel cover.
3. Remove front right wheel housing liner.
4. Remove tank for windscreen washer system.
Installing wire harness for bonnet
1. Push the water line of the windscreen washer system together with the rubber sleeve from the engine compartment side outwards through the
spring strut mount -arrow A-.
2. Install rubber sleeve from the wheel housing side on the spring strut mount -arrow B-.
INFORMATION: During removal, replace damaged clips with repair clips.