Cayenne GTS (9PA) V8-4.8L (2008)
3. Press rubber sleeve into bulkhead.
4. Install plenum panel at front left.
5. Connect connector on sensor for lateral acceleration -11- and circulating pump connector -10-.
5.1. Push on connector onto sensor for lateral acceleration in left wheel housing -arrow A- until this is felt to engage.
5.2. Push on the connector to the circulating pump -arrow B- until it is felt to engage.
5.3. Route wire harness and clip in the three retaining clips on the left wheel housing -arrows C-.
6. Push the plug connection for ABS sensor and brake pad wear indicator together -9-.
6.1. Route wire harness and clip in the three retaining clips in the left wheel housing -arrows A-.
6.2. Clip in socket for ABS sensor and brake pad wear indicator -arrows B-.
6.3. Push the plug connection for the ABS sensor and brake pad wear indicator -arrow C-, until this is felt to engage.
7. Push connector on servo valve -8-.
7.1. Push connector onto servo valve until it is felt to engage.