Cayenne GTS (9PA) V8-4.8L (2008)
/v8-4.8l/Page-343005.png)
2. Lock the secondary locking and check the optical contacts for tightness.
Removing and installing optical contacts on socket side
1. Release the spring cap on both sides using the press-out and unlocking tools for tab and round plug connectors of all sizes NR.155 and remove it.
2. Remove LWL module from the connector.
3. Position the press-out and unlocking tools for tab and round plug connectors of all sizes NR.155 for releasing on the contact locking mechanism of
the LWL module and lift the locking mechanism.
4. Pull LWL, e.g., -B- carefully in the -direction of arrow-. If it is not possible to pull out the LWL, check again if the locking is completely released.
Visual inspection of lockings, connector housing, and contacts for possible damage and if necessary, exchange the damaged parts.
Installing optical contacts on socket side
Remove the dust boot right before plugging.
Check the proper condition of the contact.
At a force of 10 N (7.5 ftlb.) the springs installed in the joint will be pressed together. This leads to an increase in attenuation, which could lead to system
impairment and system failure. Therefore, a maximum of 10 N (7.5 ftlb.) can be used to pull the LWL from the joint.
