Cayenne GTS (9PA) V8-4.8L (2008)
/v8-4.8l/Page-344005.png)
Remove the dust boot right before plugging.
Check the proper condition of the contact.
At a force of 10 N (7.5 ftlb.) the springs installed in the joint will be pressed together. This leads to an increase in attenuation, which could lead to system
impairment and system failure. Therefore, a maximum of 10 N (7.5 ftlb.) can be used to pull the LWL from the joint.
1. Insert optical contact -B- in the module until it perceptibly engages, then check the optical contact is securely fitted.
2. Insert the module in the joint on the socket side.
3. Slide the spring cap on the joint until it can be felt to engage -arrow-.
Information on the optical waveguide modules
Information about the MOST bus
In all MOST control units, at least one sending diode and one receiver diode are installed. The sending diode of a MOST control unit is connected to a
receiver diode of a 2nd MOST control unit. This results in a ring where the light signal is reinforced in each control unit (in each control unit, the light
signal is transformed into an electrical signal).
The graphic clarifies the cabling of the individual MOST control units (modules) which vary according to their equipment.
MOST control unit, variant A - D:
MOST control unit, variant A - B - D: