Cayenne GTS (9PA) V8-4.8L (2008)
Power Protection Relay: Service and Repair
Removing and Installing Cutoff Relay
Removing and installing cutoff relay
Technical values
Removing cutoff relay
Removing pyrotechnical cutoff relay
CAUTION:
Danger of injury and material damage due to incorrect handling of cut-off relay.
-
Remove ignition key.
-
Disconnect battery.
-
Route or isolate ground strap so that all contact with a ground carrier (e.g. body, seat frame) is avoided.
-
After the battery is disconnected, always wait one minute before disconnecting the cut-off relay connector.
1. Move front left seat back and up as far as possible. Move backrest fully forward.
2. Disengage front trim panel at the rear -arrow A-, then unclip it by pulling it forward -arrow B-.