porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Removing and Installing Central Electrical System Power Distributor|Page 3099 > < Removing and Installing Central Electrical System Power Distributor
Page 2
background image

1. Move front left seat back and up as far as possible. Move backrest fully forward.
2. Unclip front seat trim -Arrow A- towards the front.
3. Fold the carpet sections forward and remove the two fastening screws -1-.
4. Fold the seat back as far as possible -Arrow B-. With the seat in its folded position, move the seat forward again using the fore-and-aft adjustment

-Arrow C-.

5. Fold up carpeting -arrow- and unscrew fastening nut -2- from battery ground strap on the body.
6. Route or isolate ground strap so that all contact with a ground carrier (e.g. body, seat frame) is avoided.

INFORMATION:  Only for vehicles with auxiliary battery

7. Release the cover -Arrow A- and open it -Arrow B-.
8. Unscrew fastening nut -3- and remove line for auxiliary battery -Arrow C-.

9. Lever off lid from power distributor with a screwdriver -a- and remove -arrow-.

10. Undo both fastening nuts -4- and remove fuse element -Arrow A-.
11. Undo fastening nuts -5- and remove fuse element -Arrow B-.
12. Undo fastening nuts -6- then remove line and contact bridges -Arrows C-.
13. Undo fastening nuts -7- and remove charging relay -Arrow D-.

Removing and Installing Central Electrical System Power Distributor|Page 3099 > < Removing and Installing Central Electrical System Power Distributor