Cayenne GTS (9PA) V8-4.8L (2008)
1. Pull back carpeted floor and sound absorber slightly -A- in the front right footwell.
2. Lift carpeted floor -A- on the right side at the entrance and fold inward.
3. Unclip cover for main wire harness -B- and open it.
4. Remove the four tie-wraps and expose main wire harness.
INFORMATION: Corrosion can be identified by leads that are tarnished or discoloured instead of bright.
5. Remove insulating tape from all connection points (between 4 and 8, depending on the vehicle equipment) and check connection points for
corrosion.
5.1. Corrosion recognisable - continue with Step 6.
5.2. No corrosion recognisable - continue with Step 9.
INFORMATION:
-
To avoid mixing up the lines, one of them should be crimped again after the other connection point.
-
Allocation of lines - see wiring diagram.