Cayenne GTS (9PA) V8-4.8L (2008)
Only for vehicles with auxiliary battery
22. Fit B+ line at the holders (along left wheel housing) on the threaded bolts -arrows-.
CAUTION:
Risk of material damage to screw connections for seat and seat frame.
-
The fastening screws for seat and seat frame are coated and must be replaced after being unscrewed.
-
Before screwing in the new fastening screws, clean the thread holes with an M10 x 1.5 tap.
23. Place rear seat support in installation position -Arrow A- and tighten with fastening screws -5- - Tightening torque: 37 ftlb.
24. Attach line to threaded bolt -Arrow B- and secure with clip -Arrow C-.
25. Push connector into clip -Arrow D- until locking tab -E- is felt to engage.
26. Fasten line with new tie-wraps -F-.
INFORMATION: Tighten the tie-wraps so that the auxiliary battery line can just still be moved with the cover installed
27. Fasten cover with new tie-wraps -A- to both lines (spare wheel well) and fit the cover on the threaded bolts -Arrow B-.
28. Push cover with lines onto threaded bolts -Arrow B-.
29. Insert line with rubber sleeve in battery box -Arrow C-