porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Procedures|Page 3239 > < Procedures|Page 3237
Page 81
background image

62. Push in connectors on carbon canister -2- and on leak diagnosis pump (USA) -3- until locking tabs are felt to engage.

63. Tighten the five fastening screws on the carbon canister and the two on the degassing tank in the right wheel housing to the specified torque

-arrows-.

Only for vehicles with tyre pressure monitoring system.

64. Push connector onto antenna for tyre pressure monitoring system (rear wheel housing) -Arrow A- until locking tab -B- is felt to engage.
65. Lower the vehicle.

Lay floor carpeting in passenger compartment.

Install front right side-section trim panel.

Install right B-pillar trim panel.

Install tilt sensor control unit.

Install loudspeaker amplifier.

Install CD changer

Install control unit for trailer hitch.

Install TV tuner.

Install side trim panel for rear luggage compartment.

Install right rear light.

Install rear right wheel housing liner.

Install Kessy antenna on rear impact member.

Connect the battery.

Removing and Installing Main Wiring Harness - Roof

Removing and installing main wiring harness - roof

Procedures|Page 3239 > < Procedures|Page 3237