Cayenne GTS (9PA) V8-4.8L (2008)
3.2. Open retaining clip -arrow A- and remove wire harness for DME control unit -arrow B-.
3.3. Unscrew fastening screw -2- and the two fastening nuts -3- and remove support for DME control unit - arrow-.
4. Remove intake manifold for heater/air-conditioning unit.
4.1. Pull out retaining clip on wire harness at the intake manifold -arrow A- and unclip wire harness on the intake manifold -arrow B-.
4.2. Pull out air inlet grille -arrow C-.
4.3. Open retaining clips in the intake manifold -arrow D-.
4.4. Screw off fastening nuts -1- and remove intake manifold -arrow-.
5. Remove right firewall.
5.1. Remove oxygen sensor connector -1- from the support at the firewall and disconnect it.
5.2. Unclip wire harness at the retaining clip -2-.
5.3. Unscrew fastening screws -3- on the firewall.
5.4. Lift the firewall and seal up and off.
6. Release connector on airbag sensor at the right -1- and pull it off.
7. Loosen ground strap for front right cross member -2-.
7.1. Screw off fastening nut on front cross member and remove ground straps together with the twist lock from the threaded bolt -arrow A-.
7.2. Unclip wire harness at the retaining clip -arrow B-.