Cayenne GTS (9PA) V8-4.8L (2008)
/v8-4.8l/Page-681004.png)
Information
^
The entire threaded joints of the axle must be tightened in vehicle position. Vehicle position means: vehicle standing on the wheels, or the wheel
suspension is raised with a universal vehicle lift. Dimension -X-, from lower edge of wing to middle of axle 506 mm ± 10 mm corresponds to
vehicle position.
^
Use an intermediate layer (hard rubber). Do not damage the brake cover plate.
^
Screws are Dacromet(R)-coated and must not be greased.
^
Grease the toothing of the drive shaft slightly with aluminium paste Optimoly TA.
^
Grease axle nut with a little Optimoly TA only at mounting-face ring.
^
Drive shafts must not be left hanging from the joint stop. Support wheel carriers.
^
Use new screws and lock nuts.
^
Use a new circlip on the Quickfit.
^
Make sure the bevel pinions from the ball joints are clean. Clean with a lint-free cloth if necessary. Do not use cleaning agent.
^
Observe correct tightening torques.
1. Insert the drive shaft into the wheel hub. If the shaft cannot be pushed right in, use assembly fixture T10206 to pull the drive shaft in. Screw on the
axle nuts in order to prevent the shaft from slipping out.
2. Insert the wheel bearing housing (second worker required).
3. Fit the control arms, the spring strut and the brake calliper.
4. Fit the drive shaft on the halfshaft flange.
