Cayenne GTS (9PA) V8-4.8L (2008)
/v8-4.8l/Page-701006.png)
Information
^
Before installing, give the parts a visual check.
^
Position the rear axle housing with respect to the body at the markings made previously.
^
Position the cardan shaft at the markings made previously.
^
Replace all fastening nuts and all expansion screws (screws which are fitted with torque angle tightening procedure).
^
The entire threaded parts of the axle must be tightened in vehicle position. Vehicle position means: vehicle standing on the wheels, or the wheel
suspension is being raised using a universal vehicle lift. Dimension -X-, from lower edge of wing to middle of axle 506 mm ± 10 mm corresponds
to vehicle position.
^
Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels). When raising the suspension, use a suitable
intermediate layer (hard rubber).
^
Observe correct tightening torques.
^
The vehicle suspension must be aligned following repair work.
^
Calibrate the steering angle sensor with the Porsche System Tester.
^
Calibrate level adjustment with the Porsche System Tester.
^
Perform a function test.
Install in reverse order.
1. Position the rear axle housing on the mounting frame.
2. Pre-fit the accessories on the rear axle housing. Get another worker to help. A final tightening of the screw connections must be performed when
the vehicle is in normal vehicle position.
3. Position the rear axle housing and damper housing back in the original, marked installation position and tighten; be careful not to damage adjacent
parts -arrows-.
