Cayenne GTS (9PA) V8-4.8L (2008)
Air-spring strut at rear
1. To bleed the levelling system (compressed air must be released from the system), use the Porsche System Tester. To do this, select the Bleed
levelling system menu item in the Levelling system.
2. Fit protective tube on drive shaft (shop-made to protect the drive shaft).
3. Loosen pressure line on residual pressure retaining valve -arrow- using insert part T10212 (front spring strut connection in figure). Then, unclip
the pressure line from the holders and set it aside.
4. Remove stone guard for CDC sensor -arrow-.
5. Disconnect CDC sensor plug connection -arrow-, remove the cable from the holder, and set the cable aside.