Cayenne GTS (9PA) V8-4.8L (2008)
/v8-4.8l/Page-724009.png)
Carry out a close visual inspection of the seat of the wheel hub. There must not be scores, grooves or similar deformations on the hub.
5. Position the -wheel hub- in the correct position. Position the T10205/10 pressure piece (from attachments T10205) in the correct position on the
wheel hub. Insert the tubular piston cylinder vas 6178. Position the T10205/6 pressure piece (from attachments T10205) and the 8-2 nut for
threaded rod (from attachments T10205) in the correct position. Pull in the wheel hub. Shortly before the stop, the applied force will be between 9
kN and 35 kN. Do not exceed the maximum assembling force at the stop. -> assembling force: 40 KN
6. Fit drive shaft.
7. Press out the wheel carrier on the top axle strut (top ball joint).
8. Fit the brake disc.
9. Fit the wheel speed sensor.
10. Fit the two holders (brake hose, combination wire) on wheel bearing housing.
Subsequent work
Fit wheel.
