porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Front Suspension|Page 4174 > < Front Suspension|Page 4172
Page 2
background image

-> Do not damage the brake cover plate.
-> Vehicle may not be moved if drive shafts have not been fitted and tightened.

The wheel bearing is removed with the wheel bearing housing installed.
1. Remove the corresponding hub cap with puller hook 92291 and release the axle nut (lock nut) before lifting the vehicle. Operate the brake while

doing so (second fitter required).

2. Raise the vehicle and remove the relevant rear wheel.
3. Remove axle nut (lock nut) and the drive shaft. To remove and install the drive shaft, the rear final drive must be removed.

Tools and materials 

Tool overview for wheel bearing

Tool overview for wheel bearing

-A- - Tubular piston cylinder VAS 6178 (The tubular piston cylinder is used together with the pneumatic hydraulic pump.)
-1- - T10205/1 grip piece from attachments T10205 (To press the wheel hub out of the wheel bearing.)
-2- - T10205/2 bell from attachments T10205 (To press out the wheel hub. To pull off the wheel bearing inner race from the wheel hub, use together
with separator 12 - 115 mm [diameter] No. 111.)
-3- - T10205/3 pressure piece from attachments T10205 (To press out the wheel hub.)
-4- - T10205/4 mounting from attachments T10205 (To press out the wheel bearing.)
-5- - T10205/5 pipe from attachments T10205 (To press out the wheel bearing.)
-6- - T10205/6 pressure disc from attachments T10205 (To press out the wheel bearing. And to press in the wheel hub.)
-7- - T10205/7 pressure piece from attachments T10205 (To press in the wheel bearing.)
-8-1- - T10205/8-1 threaded rod from attachments T10205 (Used in the tubular piston cylinder -A-.)
-8-2- - T10205/8-2 threaded nut from attachments T10205 (Used on the threaded rod -8-1-.)
-9- - T10205/9 pressure piece from attachments T10205 (To press in the wheel bearing.)

-10- - T10205/10 pressure piece from attachments T10205 (To press in the wheel hub.)
-13- - T10205/13 push button from attachments T10205 (Used in the tubular piston cylinder -A-.)

Removing

Removing rear wheel bearing 

Component overview of wheel bearing

Component overview of wheel bearing

Front Suspension|Page 4174 > < Front Suspension|Page 4172