Cayenne GTS (9PA) V8-4.8L (2008)
-> Wear personal protective gear.
-> Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels).
Information
^
The entire threaded parts of the axle must be tightened in vehicle position. Vehicle position means: vehicle standing on the wheels, or the wheel
suspension is being raised with a universal vehicle lift. -Dimension X-, from -> Control value: 502 mm+/-10 mm corresponds to the vehicle
position.
^
Use an intermediate layer (hard rubber)! Do not damage the brake cover plate.
^
Screws are Dacromet(R)-coated and must not be greased.
^
Grease axle nut with a little Optimoly TA aluminium paste only at mounting-face ring.
^
Grease the toothing of the drive shaft slightly with aluminium paste Optimoly TA.
^
Drive shafts must not be left hanging from the joint stop. Tie up.
^
Use new screws and fastening nuts.
^
Make sure the bevel pinions from the ball joints, are clean. Clean with a lint-free cloth as necessary. Do not use cleaning agent.
^
Use correct tightening torques and torque angle.
Information
^
If the shaft cannot be pushed right in, use assembly fixture T10206 to pull the drive shaft in.