Cayenne S (9PA) V8-4.5L (2003)
Garage Door Opener Transmitter: Service and Repair
Removing And Installing Control Unit For Garage Door Opener
Removing Control Unit For Garage Door Opener
Remove ignition key.
1. Remove cover for interior light. From the side of the windscreen, hold onto the centre of the bulb cover and pull down the cover. Unclip the cover
of the light unit and unscrew both fastening screws.
2. Open the glasses compartment, and unscrew both fastening screws.
3. Detach the roof console around the sliding roof switch on the roof liner and allow it to hang down toward the front.
4. Compress lock "a" on electrical plug for garage door opener control unit and pull off plug.
5. Unscrew both fastening screws.
Installing Control Unit For Garage Door Opener
1. Push electric plug onto control unit until it is felt to engage.
2. Position control unit on the PCB and secure with the two fastening screws.
NOTE: Observe the line routing, danger of pinching.