Cayenne S (9PA) V8-4.5L (2003)
General Information On The Fault Memory
Fault code setting conditions
Fault codes can be set in several circumstances, e.g.:
-
battery disconnected
-
plug connections disconnected
-
power failure
In these circumstances, no fault is present in the system and the fault memory must be erased.
Fault memory Info key F8
In order to be able to assess the fault exactly, the fault memory Info key F8 must be pressed. This information should be saved using the Save key F4 and
printed out. If a fault code is stored with "not present" status and no other problems are present, then the fault memory must be erased.
Fault type - Frequency counter/Temperature/Voltage; Speed/Time of occurence
Vehicle Hand-Over
Vehicle Hand-over
The PCM2 is converted into production mode (low-current mode) in production. As known from other systems (alarm system, instrument cluster,
roll-over bar), the PCM2 must be activated with the Porsche System Tester II No. 9588.
1. Connect and start the Porsche System Tester II No. 9588 and switch on the ignition
2. Select Special functions in the Vehicle type menu and confirm with the >> key
3. Select Vehicle hand-over in the Control modules menu and confirm with the >> key
4. Follow the instructions of the Porsche System Tester II No. 9588.
Actual Installed Components List/Required Installed Components List
Actual Installed Components List/required Installed Components List