Cayenne S (9PA) V8-4.5L (2003)
3.2
Alternative tool for installing the M8 blind rivet nuts. Note: Only use if a suitable rivet gun is not available!
Important:
The friction surfaces between the washers and the screw threads must be coated with grease.
3.2.1
Functional structure: Turn M8 screw x 50 (A) with M10 nut (B) and two M8 washers (C) in the blind rivet nut (D).
3.2.2
Function: Insert blind rivet nut in the hexagon holes in the vehicle frame or rail and tighten the screw.
Tightening torque: 28 Nm (21 ftlb.).
Unscrew screw and remove nut and washers. Check that the blind rivet nut is seated properly.
4.
Positioning the holder with fitting template.
4.1
Function: Position the fitting template with the contact points (A) on the side member.
4.2
Position the holder on the contact surface (B).
4.3
Tighten the hexagon-head flat screws.
Tightening torque: 26 Nm (19 ftlb.)
5.
Install both front holders for the running board.
5.1
Position both front holders and screw in the hexagon-head flat screws.
5.2
Align holder with template (see Step 4) and tighten the hexagon-head flat screws.
Tightening torque: 26 Nm (19 ftlb.)