porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Body - Roof Box Assembly And Usage|Page 8597 > < Body - Roof Box Assembly And Usage|Page 8595
Page 6
background image

1. 4. 2

Align the two sliding blocks (underside of ski support) with respect to the width of the slots (guide rail) in the roof box floor ( ->
Figure 8 -A, arrows-).

1. 4. 3

Position thread of M8 hexagon-head bolt on the desired breaking point in the perforated strip ( -> Figure 8 -A, inset-).

1. 4. 4

Carefully press the ski support with the thread of the M8 hexagon-head bolt into the perforated strip ( -> Figure 8 -B-) until the ski
support is positioned on the guide rail.

1. 4. 5

Secure the ski support to the underside of the roof box with two M8 butterfly nuts ( -> Figure 8 -C-).

1. 4. 6

Fit the second ski support in the same way.

1.5 Lock the roof box.

CAUTION:
Incorrect fitting, use or care of the roof box
-

Risk of damage to the roof of the vehicle, rear lid and/or roof box
-

Since the roof box is large, it should always be installed and removed from the roof transport system by two people.

-

Open the roof box only if the opposite lock is locked.

-

Remove the roof box from the roof of the vehicle before washing the vehicle in an automatic car wash.

-

Keep in mind the new overall vehicle height when driving through tunnels or under low branches and when entering garages and
multi-story parking garages.

-

Clean the roof box using soapy water only (without alcohol, chlorine or ammonia additives); other substances could attack and
damage the surface.

-

Do not put stickers on the roof box. The adhesive film can dissolve the surface of the roof box or cause tension cracks.

-

Occasionally spray the locks of the roof box with a commercially available spray lubricant. The lubricant must not come into contact
with the plastic surface of the roof box.

-

When opening the rear lid for the first time,make sure there is sufficient space between the rear lid and the installed roof box. Move
the roof box forward in direction of travel if necessary.

2. Fitting the roof box on the transport system

2.1 Position the roof box on the brackets from the side of the vehicle on which the brackets for the roof transport system are open.

Body - Roof Box Assembly And Usage|Page 8597 > < Body - Roof Box Assembly And Usage|Page 8595