Cayenne S (9PA) V8-4.5L (2003)
Disclaimer
Work Procedure
1.
Preparatory work.
1.1
Remove battery cover and disconnect battery.
1.2
Remove front door trim panel, fuse box cover and door entry guard - see Technical Manual.
1.3
Unscrew the two front-most screws from the door entry trim and remove the bottom trim of the left A-pillar.
2.
Installing wiring.
2.1
Lift the door entry trim and carefully drill a hole in the front-most opening using a 6-mm drill bit (A).
Note:
Do not damage adjacent components. Arrows in Figures 3 and 4 show the direction of travel.
2.2
Position inverter (A) in the second last opening of the door entry trim and affix using adhesive tape/adhesive compound.
2.2.1 Route inverter wiring set in the door entry trim through the bore to the bottom A-pillar and fix into position.