Cayenne S (9PA) V8-4.5L (2003)
2.3.7 Release locking lug (A) on the connector strip and remove middle 21-pin connector housing "2AL" (B).
2.3.8 Press locking lugs (C) and remove pin lock from connector housing.
2.3.9 Insert pin of wire RE 0.752 of inverter wiring set into the connector housing "2AL, terminal 21" (D). Note: Ensure that pin is fitted securely.
2.3.10 Fit pin lock.
2.3.11 Clip middle connector housing "2AL" into the connector strip.
2.3.12 Clip connector strip into A-pillar.
2.4
Remove fastening frame (A) from the rubber boot "c door side".
2.4.1 Remove protective hose (B) from the door.
2.4.2 Route wire from door plug TRKP2" (A) through the protective hose to the door control module (B) and fix into place.
Note:
Observe direction of installation of wire.