Cayenne S (9PA) V8-4.5L (2003)
8. With both hands, carefully remove the camshaft adjuster and camshaft wheel out of the chain. Secure timing chain with some wire to ensure that it
does not fall into the timing case cover.
9. Remove the diamond washer which is located underneath the camshaft adjuster and camshaft wheel.
10. Unscrew fastening screws M6 x 16 of the inlet camshaft oil feed housing and pull off oil feed housing towards you.
Note: When releasing the camshaft cover, all the fastening screws must be released to an even extent in stages of half a revolution contrary to the
illustrated order so that the camshaft does not tense up!
11. Remove all the M6 x 35 fastening screws of the thrust bearing cover and bearing cover to an equal extent in stages of half a revolution contrary to
the illustrated order. Put thrust bearing cover and bearing cover down on a clean surface according to installation position.
12. Remove camshafts and put down on a clean surface.