Cayenne S (9PA) V8-4.5L (2003)
Oil Pan: Service and Repair
Installing Oil Pan
Oil pan installed (includes sealing)
Installing oil pan
Caution: Risk of damage
^
If the oil pan is not correctly aligned, it can become leaky during operation.
^
Align the oil pan extremely accurately in compliance with this description.
^
Ensure that there is no dirt between the 2 components.
1. Replace the 9 molded rubbers.
2. Apply liquid sealant. Apply the sealing agent Loctite 5900 with the hand-held cartridge. The contour of the sealing bead must comply with the
figure shown. The sealing bead should be approximately 1.5 mm high. The oil duct in the timing chain lid -A- must remain clear and must not be
obstructed with silicone.
Note: If the transmission is removed, the oil pan must be aligned with the aid of a dial gauge.
3. Place the oil pan on the crankcase and push evenly against the transmission bell.
4. Screw in a fastening screw on each corner of the oil pan and tighten them by hand.
5. Then screw in all fastening screws by hand. While doing this, push the oil pan towards the transmission.