Cayenne S (9PA) V8-4.5L (2003)
11. Disconnect ignition coil. To do this slide on the connector until it locks with an audible click.
Note: A rag should be placed between the secondary air pump and the design cover to prevent the cover from being scratched.
12. Install bracket for torque arm. The M8 x 45 Torx screws are tightened on the upper screw points to 23 Nm (17 ft. lbs.). On the lower
screw-mounting points (middle of valve cover) the M6 x 40 screws are first tightened to 5 Nm (3.5 ft. lbs.) and then to 10 Nm (7.5 ft. lbs.).
13. Slide the design cover of the cylinder bank 1-4 under the secondary air pump as shown in the picture and then slide the cover of the second
ignition coil through underneath the torque support bracket.
14. Press down the 2 rubber mounts on the support. The rubber mounts must be felt to engage.