Cayenne S (9PA) V8-4.5L (2003)
1. Clip in lines -A, B, C- in the holder.
2. Position holder with lines to the body and screw down with the fastening screws -5-. Refer to tightening torques.
3. Position the refrigerant lines -A, B- in the wheel arch and screw down with the fastening screws -4-. Refer to tightening torques.
1. Remove the plugs for the refrigerant lines -A- and -B-, check the O-rings of the refrigerant lines and if in doubt, replace.
2. Coat the O-rings with refrigerant oil. Slide in lines and tighten using both fastening screws -2-. Refer to tightening torques.
-
Fill refrigerant.
-
Observe safety regulations when working with refrigerant. Refer to, Safety regulations for working on air-conditioned vehicles and dealing with
refrigerant R134a.
-
Install front left wheel.
-
Install front left wheel housing liner.
-
Install cover, centre left.
Installing the rear vehicle floor suction line